Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
kann man bei der Visualisierung eine Standard-Maske bauen, die global gültig ist? (Vergleichbar mit Templates beim Webdesign)
Gruß
Sven
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Anonymous
-
2015-06-17
Originally created by: mg
Hallo,
Du kannst etwas machen das etwa gleich ist wie Frames im Webdesign.
Heißt:
Eine Visualiserung beinhaltet die Globalte Struktur. Top,Footer,Navi etc.
Dazu kommt noch ein Frame.
Und dann kannst du bei den Buttons - Eingabekonfiguration - OnMouseDown - "Framvisualisierung umschalten" auswählen.
Dann zeigt der Frame, je nach klick, eine andere Visualiserung an.
Gruß
mg
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Anonymous
-
2015-06-19
Originally created by: Sven O.
Hallo mg,
vielen Dank für die Antwort. Das ist doch schon mal ein Ansatz!
Gruß
Sven
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: Sven O.
Hallo zusammen,
kann man bei der Visualisierung eine Standard-Maske bauen, die global gültig ist? (Vergleichbar mit Templates beim Webdesign)
Gruß
Sven
Originally created by: mg
Hallo,
Du kannst etwas machen das etwa gleich ist wie Frames im Webdesign.
Heißt:
Eine Visualiserung beinhaltet die Globalte Struktur. Top,Footer,Navi etc.
Dazu kommt noch ein Frame.
Und dann kannst du bei den Buttons - Eingabekonfiguration - OnMouseDown - "Framvisualisierung umschalten" auswählen.
Dann zeigt der Frame, je nach klick, eine andere Visualiserung an.
Gruß
mg
Originally created by: Sven O.
Hallo mg,
vielen Dank für die Antwort. Das ist doch schon mal ein Ansatz!
Gruß
Sven