Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
folgendes: ich möchte bei einer analogklemme 750-474 an einem controller 750-841 das statusbyte (sprich fehlerdiagnose) auslesen. im handbuch des controllers steht, dass er nicht auf dieses byte zugreift. aber da gibts doch sicherlich einen trick, oder?
gruß
björn
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hallo leute!
ich mal wieder.
folgendes: ich möchte bei einer analogklemme 750-474 an einem controller 750-841 das statusbyte (sprich fehlerdiagnose) auslesen. im handbuch des controllers steht, dass er nicht auf dieses byte zugreift. aber da gibts doch sicherlich einen trick, oder?
gruß
björn