Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Codesys 2.3, Schieben von Datenwörtern (16Bit) BMOVE

JoergH
2017-08-30
2017-09-28
  • JoergH - 2017-08-30

    Hallo und Moin,

    komme von der Mitsubishi-Seite und bin jetzt mit Codesys (WAGO/PFC200) angefangen, was eigentlich soweit ganz gut funktioniert. Ein Problem habe ich, welches ich trotz Recherche nicht wirklich lösen konnte. Ich möchte einfach nur Blöcke von 16Bit Datenwörtern nach anderen Datenwörtern verschieben (bei Mitsubishi "BMOVE D100 D500 K3", Schiebe D100,101,102 nach D500, D501, D502 (jeweils immer 16 Bit)). Dann wüsste ich in diesem Zusammenhang noch gerne wie ich ein Datenwort (16Bit) in ein Merkerwort wandeln kann.

    In meinen Libraries "Standard.lib" und "Oscat_standard_333.lib" bin ich nicht fündig geworden. Wahrscheinlich Brett vorm Kopf Syndrom. Danke Euch schon mal im Voraus.

    Gruß Jörg

     
  • Erik Böhm - 2017-09-28

    Moin
    Kann es sein das du SHL und SHR suchst ?
    Siehe Online Hilfe im Codesys.
    Gruß Erik

     

Log in to post a comment.