Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Ich habe ein Problem mit der Wago PWM Karte (100HZ)
Wenn ich die Karte Manuell in die Konfiguration einfüge wird der K-bus nicht gestartet.
Lese ich die Konfiguration mit Codesys aus und übernehme sie automatisch in das Projekt wird mir eine Standard karte 750-511 angezeigt die nur 2X Analogausgänge hat(2x int). Normal müsste die karte noch Status und Control Ein-Ausgänge habe, so wie, wenn ich sie mit Hand einfüge.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Ich habe ein Problem mit der Wago PWM Karte (100HZ)
Wenn ich die Karte Manuell in die Konfiguration einfüge wird der K-bus nicht gestartet.
Lese ich die Konfiguration mit Codesys aus und übernehme sie automatisch in das Projekt wird mir eine Standard karte 750-511 angezeigt die nur 2X Analogausgänge hat(2x int). Normal müsste die karte noch Status und Control Ein-Ausgänge habe, so wie, wenn ich sie mit Hand einfüge.
Hi,
kannst du bitte mal ein 'BugReport' lostreten über den CODESYS Store (einloggen) - meine Frage?
Denke da gibt’s ne Lösung.
Grüße
Edwin