Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hallo,
ich habe einen BB Black als EtherCat Master und zwei Motorsteuerungen mit entsprechenden Motoren der Firma Nanotec als Slaves. Beim Ausführen meines Testprogramms steht im Status des EtherCAT Masters : "EtherCAT : läuft nicht".
Wo könnte mein Fehler liegen?
Gruß Tim
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hallo,
ich habe einen BB Black als EtherCat Master und zwei Motorsteuerungen mit entsprechenden Motoren der Firma Nanotec als Slaves. Beim Ausführen meines Testprogramms steht im Status des EtherCAT Masters : "EtherCAT : läuft nicht".
Wo könnte mein Fehler liegen?
Gruß Tim